Migulel

21 / 1

20th August

30th August

To start up: open the CST 1 valve or CST 2 valve or both to allow condenser to get water withdraw rods and monitor the temp its good to keep fuel rod temp at around 700 at startup open turbine preheat valve to preheat turbine rest of instructions are in

bwr4 nuclear mark2 light turbine reactor water boiling mark powerplant

Comments

GottaLoveFlying 4th September

also have a way to actuvely keep your condenser hotwell levels equal (equalizing pipes work well)
GottaLoveFlying 4th September

output of the turbine heating should either be feedwater heaters (which u dont have) or condenser instead of merging back into the MSL
GottaLoveFlying 4th September

use normal pipes in between sections of ppips cuz currently it kills your flow rate
GottaLoveFlying 4th September

also recirculation is not helping in this reactor nor accurate to how it should be
GottaLoveFlying 4th September

left being on and right being off is quite unusual xd
GottaLoveFlying 4th September

also the vent in the fuel is creating a big hot spot
GottaLoveFlying 4th September

i remember this short mk2 containment xd
Migulel 30th August

20 LIKES!!!!!!!!
Migulel 29th August

i improved condenser and when i tested this thing for about 20 mins straight i noticed a couple of issues that i will try to fix like condenser circulation water boiling or reactor overpressure and i will try to get rid of these issues
Migulel 29th August

guys should i upload an already running version of it so you dont have to do the complex startup

The Powder Toy

Mark II BWR/4 by Migulel

Comments